DIY Louisiana Solar Company Plans
Building your own louisiana solar company panels can be the most rewarding do-it-yourself project you ever undertake. The cost savings in monthly electricity costs can easily pay for itself in as little as a couple of years. With diy solar plans and minimal building skills, you can have your own solar assembly up and running in no time. With prefabricated solar panels running you $1000 a piece, DIY solar has become a very attractive choice for thousands of homeowners.
To build a solar panel you wil need the following materials; 36 whole monocrystalline cells, copper tabbing wire, a flux pen or heat resistant adhesive, electrical jack, blocking diode, masonite pegboard, and a solder.
For the enclosure you will need; plexiglass, plywood, wooden molding, and silicone caulk.
Once you have the materials on hand, you are ready to put together the solar panel.
How the Solar Panel Will Look When Finished.
Lay the 36 solar cells out on the plywood, arranged in rows of 6. This will give you a good idea of how the louisiana solar company will look when finished.
Solder the solar cells together, connecting the copper tabbing wire to each solder point. Start in the top left, going from left to right down the layout. Handle the solar cells with care as they are extremely brittle. You may choose to purchase a few extra solar cells in case a couple break in the process.
Using a voltmeter, test the array’s output. For this example, 36 cells, you should have an output of approximately 18V.
Next, dab each solar cell with the flux pen. After you’ve dabbed each solar cell, place the pegboard over the top of the solar cells, carefully covering all the cells. Flip the entire arrangement so that the solar cells are facing upward.
Cut off any extra pegboard.
Once you have assembled the louisiana solar company, you will need to build the enclosure. Once you have placed the panel in the enclosure and sealed it to make it water resistant, you will need to decide on how to connect the electricity. You will probably need a battery to store the electricity. Most people choose a 12V battery. If you have enough electricity to connect to your grid, you will need an inverter. Inverters convert 100 watt solar panel electricity from direct current (DC) to alternating current (AC).
The entire process will not take you much longer than a weekend if you have decent building skills. It’s a very easy process and should be a lot of fun if turned into a family project.
